Waiting for you to follow us in these SNS, thank you. 
0086-17322110281
info@moldclamps.net

DGMF MOLD CLAMPS CO., LTD
·

Complete Specifications

Adequate Inventory

Factory Outlet

Fast Delivery

Quality Assurance

Competitive Price

Customizable

Our Mold Clamps Make Your Machines More Efficient And Durable, Lower Maintenance Costs!

Request for Inquiry
MOLD CLAMPS
+
+
NEWS    PRODUCTS
DGMF MOLD CLAMPS CO., LTD

Dynamic news
17 Common Problems And Solutions For Stamping Dies
Original: Original | Author: DGMF Mold Clamps | Publish Time: 2020-08-20 | 10184 Views | Share:
This article summarizes 17 common problems of stamping dies and lists some solutions for your reference.

10) The punch is too thin, too long, and not strong enough to change the punch type

11) The punch hardness is too high, and the punch material is wrong. Replace the punch material and adjust the heat treatment hardness

6. Iron filings

1) Recalculate the bead position or bending position when the bead is misplaced

2) The bending gap is too small, extrude the iron filings to adjust the gap, or grind the forming block, or grind the forming punch

3) The bending punch is too sharp to repair the R angle

4) Too little material for the cutting edge reconnect the cutting edge

5) The bead is too narrow to re-grind the bead

7. Poor sprouting

1) The center of the bottom hole of the sprout and the center of the sprout punch do not coincide. Determine the correct center position, or move the sprout punch position, or move the sprout-side high-side low or even break the pre-punching position, or adjust the positioning

2) The gap between the dies is uneven, resulting in low budding-side high-side trimming and low budding gap or even breakage