Waiting for you to follow us in these SNS, thank you. 
0086-17322110281
info@moldclamps.net

DGMF MOLD CLAMPS CO., LTD
·

Complete Specifications

Adequate Inventory

Factory Outlet

Fast Delivery

Quality Assurance

Competitive Price

Customizable

Our Mold Clamps Make Your Machines More Efficient And Durable, Lower Maintenance Costs!

Request for Inquiry
MOLD CLAMPS
+
+
NEWS    PRODUCTS
DGMF MOLD CLAMPS CO., LTD

Dynamic news
17 Common Problems And Solutions For Stamping Dies
Original: Original | Author: DGMF Mold Clamps | Publish Time: 2020-08-20 | 10180 Views | Share:
This article summarizes 17 common problems of stamping dies and lists some solutions for your reference.

1) The pinhole is not cleaned. Wipe the pinhole and the pin clean. When removing the mold, the positioning pin should be removed first. When the mold is easily damaged, use the screw to guide the hole first, and then drill the positioning pinhole.

2) The procedure of assembling and disassembling the mold is not correct. Do not damage the pinhole when knocking down the pin.

16. Locating pin

1) When the whole wall is fuzzed or the mold is too tight due to scratches, carefully check whether the pinhole is fuzzed, otherwise, the pinhole should not be punched out and re-reamed

2) The pinhole is offset or there is no escape hole underneath, add positioning pin escape hole

17. The spring is too long

1) Did not pay attention to the depth of the spring hole, measure the depth of the spring hole, calculate the compression amount of the spring, and re-select the

2) Not careful enough, lack of experience and proper spring bottom dead center